Honeycomb Medal Hanger (Improved)

Honeycomb Medal Hanger

V3 Major Update.

These Medal Holders now use 20g LESS Filament. I've also changed the infill to save filament and upped the quality by slowing down and thinning the top surface layer lines.

I have optimised the medal hangers to include a small block inside at the bottom to help hold heavier medals vertical.

I have also added 2 options for the size of the inner circle piece. Loose or Snug.

Loose Fit (Lighter Medals)

This is the smaller inner circle that leaves a small gap around the outside. Generally good for lighter medals.

Snug Fit (Both Heavy and Light Medals)

For this version I have increased the size of the inner circle as big as possible to create a snug fit leaving no gap around the outside. This is better suited for heavier medals.

I've sized this medal hanger to closely match the (conqueror honeycomb medal hangers)

140mm X 160mm

I've made it a little deeper than the wooden conqueror medal hangers to make it easier to fit all the ribbon inside.

Magnets required are 10mm X 2mm. Just simply pressed in. Glue for extra security.

The back is completely flat which is perfect to be mounted on the wall with command strips.

Different Shapes Below.

You can find my Circle Medal Holders here;

Circle Medal Hangers by 3DPrintingCF MakerWorld: Download Free 3D Models

You can find my Square Medal Holders Here;

Square Medal Holders by 3DPrintingCF MakerWorld: Download Free 3D Models

You can find my Smaller Hexagon/Honeycomb Medal Holders Here;

Honeycomb NANO Medal Holder by 3DPrintingCF MakerWorld: Download Free 3D Models

The back is completely flat which is perfect to be mounted on the wall with command strips.