Death Scythe Boomerang

Death Scythe Boomerang

A very cool toy with a maximum diameter exceeding 50cm.

Printing:

• Before printing, please thoroughly clean the build plate, as the model is large to prevent warping.
• After printing, please remove the model only after the heated bed has cooled down.
• Please use PETG material for printing.
• Print one copy on plate 1 and four copies on plate 2.
• Monochromatic printing is sufficient; the image shows multiple colors because I ran out of materials.

Assembly:

• The model is printed in parts; finally, use the connecting blocks to connect them. There will be gaps at the joints, which is also a shortcoming. In addition, printing in parts will reduce the overall strength, so please avoid bumping it.
• During assembly, insert the connecting block into the recess little by little. If the last part is not smooth, you can tap it with a mallet; you can use the bottom of an insulated cup.
• The method for installing the dart head is the same.

How to Play:

• Insert your palm into the small slot, adjust the position, and push the dart with your thumb.

  

• Insert your palm into the large slot, adjust the position, and push the dart with your thumb. Then you can make a fist, holding the center crossbar.

  

Precautions:

• This dart should not be thrown.
• Do not touch it while it is spinning.
• Do not use it to harm plants or animals.
• I am not responsible for any safety issues arising from this model.

Acknowledgements:

• If you encounter any problems during printing and use, please leave a message below, and I will reply to you promptly after seeing it.
• If you like this model, please support me, thank you very much.