Spanking Paddle

52 cm long traditional spanking paddle with holes to reduce air resistance.

ASSEMBLING:

Printed in two parts, assembled together with force. The connection is designed to hold firmly forever and withstand hard use, so force is needed to assemble. I personally used two construction clamps and was tightening gently. It went together with no problem. If you do not have construction clamps, use rubber hammer, handle of screwdriver, anything.

Included are test parts - I suggest print them first, then try how it comes and what force do you need to apply to go together. 

I suggest to use few drops of superglue when in half of assembling - just assemble, press together to the point where you are half finished, then add drop of superglue on friction planes. Then press together until it looks like one part, and it will be firm forever as printed in one piece.

PRINTING:

I have printed with PETG, because I like PETG. May work with PLA, I dont know, there are forces in the connection - use test parts to figure out if you wish.

Connection needs to be tough, so maybe use modifiers and choose infill about 80% in that area.

Choose percentage of infill to your likings. I wanted hard, heavy tool, so I chose 80% for the entire thing. I got 300 grams heavy paddle, capable of bringing any sub to tears (true story!).

I also added ironing, and the surface is nice, shiny and sting like hell on bare skin. 

Enjoy!