Search models, users, collections, and posts
Gohan SSJ2 Statue DBZ
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
5.5 h
1 plate
Open in Bambu Studio
Boost
287
619
28
10
455
223
Released
Description
Hello again!
I have scanned and edited an SSJ2 Kid Gohan statue.
- It uses a decent amount of tree support, so make sure to be careful when removing the hair.
- Tested on A1 mini
- I would advise putting some sticky tack or double-sided tape for more stability of the figure
Sorry for the delay, my A1 mini is being unreliable. I might use up my points to buy the full A1.
Boost Me (for free)
Support me if you would like :)
Thank you for all of your support and feedback, I have more models on the way!
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (28)