Tiny XT - 1/10 scale retro PC

It's a classic retro PC, just really small! Inspired by the new bone white PLA filament from Bambu Labs.

This is a complete miniature PC building kit, case, motherboard, PSU, floppy drive ,hard drive and expansion card. There's even a 5.25" floppy disc!

All parts print in orientations to make them detailed but also reducing waste and need for support. 

There are two floppy drives. One has the front locking lever printed in place, the other has it separate. The separate one requires tweezers to push it into place, but then it can be moved like the real one. The floppy disc can be inserted, but would also require tweezers to remove it if you push it all the way in. Pick one version of the drive to print, unless you want to use both drive bays on the left.

PCBs for floppy and hard drives need to be glued in place once printed.

Red power switch is tiny and also needs carefully fitting with tweezers.

The chassis frame needs to be folded up and glued into place. The front part glues under the drive bays where there is an alignment pin, for the rear part - slot the PSU into the block for the side power switch, with glue to hold it to the rear panel. Then glue the PSU down to the chassis base to hold it all square.

The other components are all friction fit and just slot into place. 

Printed with a 0.2mm nozzle on a P1S using bone white for the case, others are just white, black, green as you would prefer.