AMS 2 Pro Complete stay dry solution - V7

The Complete stay dry solution for the AMS 2 Pro.

These will not only help the AMS 2 Pro keep the filament dry, but since the AMS 2 PRO has a heat function, it can also be used the dry out wet silica, just be sure to print them in a filament that can take the heat.

The venting / holes are just short of 2mm, some cheaper silica solutions contact broken / very small beads hat may slip through these gaps. In these cases, please gently shake the filled tub over a container to collect any broken beads that fall through. 

For the best performance I recommend Industry Standard 2-4 mm silica bead.

UK - https://amzn.to/4jeGMCF 

US - https://amzn.to/3FTKByV 

If you like to use spools larger than the recommended 202mm you may prefer my oversized spool friendly version

https://makerworld.com/en/models/1313630-ams-2-pro-dry-box-over-spec-spool-friendly#profileId-1348341 

Version 2 of the in spool silica tubs can be found here

https://makerworld.com/en/models/1705030-in-spool-dry-tubs-v2#profileId-1808538 

UPDATES - Please be sure to use the designer profiles to know you are printing the latest version.

If you have any suggestions to improve this product please let me know. See below improvements that have been made thanks to your suggestions;

V2

• Added Hygrometer box.
• Added vented lids on the larger boxes.
• Lids on small boxes tightened.

V3

• Added in spool silica tubs.

V4

• Clearance between boxes and spool increased by 3mm to eliminate any rubbing on larger spools.
• Redesigned back for easier fit (see gif).

V5

• Hygrometer 2.0 added, this is stronger, fits both 12-6 and 11-5 round Hygrometers, Hygrometer is easier to insert and remove.

V6

• Rear dry box added.

V7 - 19/04/25

• Funnel Jug 2.0 added.

This was tested in Bambu labs PETG HF. Even though I have designed the model to have some tolerance to allow different filaments (and print settings) and the varied amounts of shrinkage we see you may find it to be either too snug or too loose.