Lord of the rings 2 - hueforge - Free 3D Print Model

Search models, users, collections, and posts

Altf4-Formation

Art>2D Art

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.08mm layer, 1 walls, 100% infill

Designer

4.7 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Bill of Materials

Bambu Filaments

Select all

Description

My photos are indeed those of the printed model and not of the original image

-------------------------------------------------------------------------------------------------------------------------------------------------------

Commercial license and exclusive models on Ko-fi!

Thanks!

-------------------------------------------------------------------------------------------------------------------------------------------------------

Hueforge of Lord of the rings - The two towers by artist Doaly
The photos shows the result in 200*133mm and a nozzle of 0.4

Boost Me (for free)

Thanks for your boost!

You can change the X and Y dimensions but do not change the Z dimensions
You must define the printing parameters indicated in the description below and change the filament on the indicated layers.
You can use filaments other than those indicated, but the result will differ.
You can use any black PLA

Hueforge description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 133.12x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.6mm and the Actual Depth is 2mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Mistletoe Green Transmission Distance: 1.1
    PLA BambuLab Basic Jade White Transmission Distance: 5
    PLA BambuLab Basic Marron Red Transmission Distance: 1.3
    PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Mistletoe Green
    At layer #10 (0.88mm) swap to Jade White
    At layer #16 (1.36mm) swap to Marron Red
    At layer #17 (1.44mm) swap to Yellow for the rest.

-------------------------------------------------------------------------------------------------------------------------------------------------------

Don't forget your grandma's advice: Always have a clean plate, a dry and calibrate filament, and make an offering to the god of 3D printing from time to time.