Print Profile(2)
Bill of Materials
Description
Here you can get a self-standing frame for lithophane pictures.
The frame has the following outer dimensions: 130x170x36mm
The pictures must have the following dimensions to be inserted: 120x160mm (max. thickness: 5mm)
The backlight board and the lithophane picture are inserted into the frame from below, with a cutout on the back of the frame for the USB-C port of the backlight board.
Then the lid is pushed onto the frame from below, you should proceed with some caution, as it can be a bit stiff at first. When opening, move the lid back and forth a little and pull it off carefully, otherwise the small legs could break off.
The frame is also suitable for landscape format.
The backlight board used is the original CMYK backlight board from Bambu Lab. However, I have also tested other third-party backlight boards.
I recommend this one here: }} Backlight Board {{, as this one comes with a connection cable with switch and dimmer.
Boost Me (for free)
If you like my model, please leave a like or boost me, thank you very much
Note: Apparently not all LED boards are the same, therefore I have created a profile (wider version) where the slot fits 2mm thick boards.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (204)