Samsung Galaxy A56 TPU phone case

Samsung Galaxy A56 TPU phone case.
Designed for bed plates with patterns in order for the pattern to be transferred onto the phone case.
If you dont own a plate with a pattern it will still print ok but you wont have the nice pattern on the back of the case.

*20/12/25 model updated to fix camera and top microphone cutout alignment as users mentioned misalignment on the previous version.

 

Features:

• Rigid side walls to avoid sides that are too soft and move out with the movements of your fingers leaving the top unprotected in case of a drop.
• Round side walls for nicer feel and more side rigidness
• The usb cutout is large in order to fit all kinds of usb cables
• 2 Versions available one with thick bottom to keep the camera protected one with thinner bottom to make the case thin
   

The print profile has custom supports painted and enabled.

the supports get removed easily if you start pushing them away from the bottom part of the USB cutout.

Push the bottom of the support from the outside of the case towards the center of the case and when the support detaches just grab it and pull until all of it is out.
The bottom support clearance is 0.5mm so the supports come out easily and dont leave any serious marks on the case.
Once you remove the supports make sure to check properly the top solid layer of the case where the supports previously sit on as most of the times the first layer of the support stays on the case. 

you have to remove it before putting the phone in as the phone wont sit properly if you dont remove it, and the case will be slightly deformed.
the line gets removed easily by scratching it with your fingernails and pulling out or by sliding a X-acto knife under it.