Search models, users, collections, and posts
MatchFit Setup Gauge
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
59 min
1 plate
Solid Kerf Trim part & PDF included
1.3 h
1 plate
Open in Bambu Studio
Boost
49
183
23
8
209
165
Released
Description
I modeled the MatchFit Setup Gauge because, for every blade, you have to have another one.
A total of two 6mm x 3 mm magnets are needed allowing this to magnetize to table saw top. These should press fit depending on the accuracy of your printer. Add some super glue if loose or use a clamp to press if to tight.
Download the PDF and print at 75% to glue on the jig. I used regular paper and glue stick. Spray glue would be better.
License
This user content is licensed under a
Creative Commons Public Domain
Comment & Rating (23)