Print Profile(1)
Description
A small organizer to get your paper clutter upright and out of the way. The wave design lightly pinches to keep things standing straight for a clean look. The outside slot is larger for a notebook or thick stack.
RH and LH versions for either side of the desk (LH pictured). Versions with recesses for ½" diameter rubber feet are also available (last picture), just because I put them on everything. The model otherwise has a flat bottom.
Minimal strength requirements for filament usage reasons, I printed with 2 wall loops and 15% infill with PLA. More strength is fine of course.
Supports are not needed if your printer is decent with overhangs (though they will probably save you a little clean up work). A shorter layer height seems to print nicer, 0.16mm was fine for me.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (25)