Dog Poo Bag Dispenser 2x - Leash Mount

A dispenser for dog poo bags.  Designed to mount to the side of a leash; for instance Flexi brand as shown, but should work on anything this size with a relatively flat side.  It has two compartments, because nothing's worse than trying to be a responsible pet owner but it turns out there was only one bag left on the roll and furbaby decides today's they day they need to poo two or three times.  I've also included a little hook at the bottom to give a convenient spot to hang the pull bags off of, to keep your hands clean and free until reaching a garbage.  I've easily fit two bags on the hook; could fit three I think as long as the knots are tied tightly.

The dispenser is intended to mount with foam adhesive strips (like 3M foam tape), but superglue or epoxy could work too, and I included 4x holes if you want to use screws.  Lids attach magnetically, can use sets of 1, 2, 3, or 4 connections per lid.  I found 2 to be a little light (lid could come off if the leash is shaken or dropped), and is a bit too firm with 4 sets.  So 3 is I think the ideal.  Magnets are in the BOM, purchased from Bambu.  Maximum is 16x magnets if you use all the spots provided.  Magnets are a slip-fit into their holes to allow for different printer accuracies and setting; dab a drop of superglue into the hole to retain them.

I recommend a tougher filament as leashes can get dropped and banged, etc.  I've had good results with PETG; try PLA at your own risk.