Search models, users, collections, and posts
Ender Pearl
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 7% infill
Designer
4.1 h
1 plate
Open in Bambu Studio
Boost
284
527
50
12
593
309
Released
Description
Modeled this Ender Pearl using Makerlab's AI generator: Powered by Image-to-3D from MakerWorld (https://makerworld.com/makerlab/imageTo3d)
Theres a little spot that is kind of weird but I'm not savvy enough to edit an OBJ model, and since it was small enough I could pull it off without it looking bad I just let it be.
Used translucent PETG from bambulab, 7% infill and used PLA for support where the supports meet the part (life hack I recommend everyone use, they basically just fell off. Use PETG for support interface for PLA and it has the same effect…)
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (50)