Search models, users, collections, and posts
Fortnite ChugJug V2 NO AMS
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 8% infill
Designer
6.9 h
4 plates
200% scale! (0.2mm layer, 2 walls, 8% infill)
8.9 h
4 plates
Open in Bambu Studio
Boost
47
89
16
6
120
54
Released
Description
This is a PLA - No AMS ChugJug Version with Paused prints.
Print the inserts Turquise or orange"ish" for the exotic
Print the Bumper and use the inlay pauses at layer 210 and 265 to insert and press the Inserts into place and resume the print.
(inlay needs to face “PLATE SIDE UP” or else they wont fit correct.)
Print the screw on top and bottom.
Print the topcap, remoce the supports and pres it firmly into the hole of the top lid.
Enjoy your model Chug Jug.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)