Search models, users, collections, and posts
Print Profile(3)
iPhone 16 Adhesive Case V2 with MagSafe
Designer
1.2 h
2 plates
0.2mm layer, 3 walls, 10% infill
Designer
42 min
1 plate
Source file customizable (including side walls): 0.2mm layer, 3 walls, 10% infill
Designer
51 min
1 plate
Open in Bambu Studio
Boost
9
15
2
1
30
16
Released
Description
Content has been automatically translated.
Attachment method: 0.6~0.75 mm thick, 10 mm wide nano adhesive (double-sided tape)
Note:
- sinkage rate calibration is required before printing, slight misalignment may occur after pasting, perfectionists please proceed with caution
- This case offers no protection for the front of the phone
Design intent:
- Flatten the annoying camera bump on the back
- Minimal bezel footprint and thickness
- Does not affect heat dissipation or hand feel
Compatibility:
- iPhone 16
2026 - 02 - 03 New version (V2) update:
- Slightly reduced sidewall thickness and discontinued support for the sidewall-less version
- Added MagSafe support (requires purchased accessories, to be embedded into the slot during print pauses)
- Optimized some model details to enhance user experience
- MagSafe accessory notes:
- For accessory compatibility, print the sample file from plate 2 for comparison
- Accessory thickness must be strictly less than 1.2 mm
- Confirmed support for magnetic rings containing magnets; iron rings without magnets have not been verified
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)