jewelry box

Hello,

I made this jewelry box for my girlfriend. So she can store rings, Earrings and other stuff like necklace.

I made inputs for little magnets that the Drawers shut in a straight line. You need 16 of these.

I used 5x1mm Magnets.
I also made a version for 6x2mm and 6x2,7mm Magnets. 

For Printing:
You need the Parts of the general folder and the parts of the folder with your desired Magnet size. 

You have to print 4 Drawers of your choise. If you want to print the Earring and ring Drawer, you need the ring holders and Earring holders. If you only want rings, you can print the “ring holder for earring compartment”.

It Should be possible to print every thing without support. I had no problems printing it without support on my bambu lab.

You need four drawers. Put them above each other and glue the axis and top in place.

If you want the drawer for Rings and earrings you need:

• 2x Every Earring holder
• 1x TPU Ring holder left
• 1x TPU Ring holder right
• 1x The Drawer for rings and earrings

I would print the Ringholders in TPU that the rings get no scratches and are easy to put in and remove.