Smiski Heaphones

Feeling sad because you didn't get that special secret Smiski? Here is a simple way to accessorize your regular Smiskis with their own stylish set of headphones. After a few iterations, I ended up modeling these after those worn by the secret hipper, where the cups are more rounded and the headband fits snuggly around their head. This was all done in Tinkercad since I'm still learning other programs, but I might revisit this simple project once I level up. I picked a 0.08mm layer height since it is such a tiny model, but it is still a quick print (under 21min) and uses under 2g.

Notes: Add a small brim if you have adhesion issues, though I printed it multiple times on a SuperTack plate with no failures. You might get a warning about floating regions when you slice the model. This is due to the cutouts for the headband and the cupping of the earpieces. I chose not to enable supports since those sections should be good enough with most printers (and they're hidden from view while worn). I tried painted mini tree supports but the improvement was not worth the extra hassle of removing them (yes, we do have about ten pairs laying around from various iterations). You can use a small pick or hobby knife to clean any blobs from the holes where the headband fits, if needed. I wanted them to come together tightly without needing glue. The cups are symmetrical, and you should be able to get the band to slide nicely into each side. I printed one pair in Basic Green, the second one in glow green which I painted with an acrylic marker that better matches the Smiski green, while still glowing a bit under UV lighting.