Boost Base Rocket League - with LED lamp version

🚨ATTENTION 🚨

1. You can use ANY car you want to use this boost base.
   1. I used the Fennec by C23_Dixon but I made a change on back light from the original file to snap the magnets on it
2. 🚨🚨🚨 VERY IMPORTANT -  The car should be light, otherwise the magnets will not hold the weight.
   1. When I printed the Fennec ☝️I didn't pay attention to that detail, so the car was 173g (without wheels) and this was very heavy for the magnets.
      

   2. So I had to do a workaround because I didn't want to reprint the car
      
      I dug a hole in the car to try to reduce its total mass as much as possible, the car now is 143g (with wheels) 
      and I covered the hole with a piece of PLA (0.4mm height about ~2 layers)
       
      - the ideal weight would be below 120g for only 4 magnets (2 on car and 2 on boost base)
      but in my case the car still over the ideal weight, so I used 6 magnets (2 on car and 4 on boost base) 
      

      💡💡💡So when you go to print the model try to decrease the infill and increase the wall loops (for a high quality)

3. FOR LED LAMP

   1. Open a space where you want to pass the power cable

      

   2. When you finish placing the LED inside the boost base, glue it with super glue
      

👉 🔗 I have attached all raw files to this post, so feel free to change it and help the community 💜💜💜

💜Like this model? ☕ Buy me a coffee!
https://buymeacoffee.com/pedrohymino

👀 See More

• 🔗 Pee Pad Magnetic Holder
• 🔗 Dog Wardrobe with Ikea Smussla
• 🔗 Industrial Pipe Shelf
• 🔗 Macbook slide cam cover
• 🔗 More models