Search models, users, collections, and posts
Chain connector link
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
59
125
4
3
221
124
Released
Description
This is a connector link that can be used to join multiple lengths of chain. This is designed to go with the other print-in-place chain link model I have here, but it could be used for other things too.
Note - it will require a bit of force to bend it enough (I twist it) to get it onto the chain. This is intentional so that it does not come apart on it's own. It will fit though.
https://makerworld.com/en/models/1049901-round-chain-print-in-place#profileId-1036470
Also, If you would like to sell physical prints of my standard license models only, you can join my Patreon here. This license does not allow selling or distributing the digital files, and your membership must remain active while you sell physical prints.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)