Ann Arbor Railroad Coasters & Holder

Ann Arbor Railroad Coasters

This Ann Arbor logo was from during the timespan they were under Wabash control.

I will have the Ann Arbor coaster holder as a separate profile. If you don't want to print the holder with the Ann Arbor logo, you can print the plain square coaster holder i have listed.
 

These coasters are 89mm square and 3mm thick.

This print profile worked just fine on my X1C

  I used an initial layer line with of  .03 due to the small lines. You might be able to get good results using the .05, I'm not sure. 
If you have issues printing the .03 I would suggest maybe using a little bit of Aqua Net hair spray on the plate.
 

I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will have to trim them. https://a.co/d/0PjaF1i

Take a look at my other railroad and non-railroad coasters and clocks at https://makerworld.com/en/@railimages