Cubicle Hook V1 and V2 and Headphone Hook

I was inspired to make this hook from a hook that I used in a  previous cubicle but since our new cubes were Unicor Crescendo the hook latch holes are deeper so the original hook didn't stick out enough for coats or backpacks.  This one fits nicely and works well!  I like to print them with 6 walls and 20% infill.

I have added a new L version hook (V2) as well as an L version headphone hook!  They have sleek rounded edges.  These are both 7mm thick but you can reduce to 3mm in your slicer if needed.

Remember at least 6 walls and 20% infill!  I have seen them break under slight pressure with only 2 walls and little infill.