Search models, users, collections, and posts
Curling and warping calibration test
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
2
16
1
0
29
10
Released
Description
This lets you test the curling occurring on any layer. I had problems that the side didn't look good in one of my prints and I found out that curling was the problem. I created this test to play with the settings and improve the final result. I suggest the usage of supports.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)