Search models, users, collections, and posts
Retro TV X1C screen Cover
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 15% infill, tree supports, 4 colors
Designer
3 h
2 plates
Open in Bambu Studio
Boost
184
354
33
12
286
140
Released
Description
Printed using (1) Matte Brown, (2) Matte Black, (3) Matte Red, and (4) Matte White PLA filament.
Should slide on relatively easily once printed, it does block the sd card slot once installed however there are no issues with fit if the SD card is pre-installed. Antenna print is optional, tolerance is tight. Mine twisted in fine but you may need to clear out the required hole for it with an allen wrench or small screwdriver. Supports are required for main screen.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (33)