Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
40 min
1 plate
Open in Bambu Studio
Boost
49
126
8
0
196
135
Released
Description
Model of a small (3cm) beach ball for summer decorations. AMS not needed but it helps. Prints in four separate pieces that need to be glued together. Minimal supports on the center piece, and no filament changes between layers. A few drops of superglue will hold the wedges to the core.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)