Six-winged High-speed Fighter (Articulated, No Hardware Required)

This is a Six-Wing Swift Fighter The wheels can rotate, and the two small wings on top of the cockpit can be opened by pressing backward Note: if the edge of the cockpit canopy has burrs, it will be difficult to open The overall design features a streamlined fuselage to reduce wind resistance, and is equipped with 2 cannons, 2 small machine guns, 3 powerful engines, and 6 high-strength wings to prevent tearing at high speeds (I made this up (´▽｀) )Small size: LWH approximately 94.4*72.2*35mm)

2025.5.7 Update:

1. Added 1.5x larger version Due to the oversized dimensions, the wings would collapse without support, and software-generated supports were not aesthetically pleasing After 10 failed attempts to print wing supports, supports were finally added manually through modeling, allowing for printing with minimal impact on the wings' aesthetics (Preview images updated)

2. Users suggested that a slight tilt to the fuselage would look better, so the front wheel support was increased by 2mm

The base component and wheel component are installed as a 2-in-1 option If one is not needed, you can skip printing it via the mobile app, which will be faster~

Note: PETG is recommended for printing the wheel component part, PLA is not smooth In the GIF below, the blue part is PETG, and the red is tape for easy observationOverall installation is relatively simple (Some force is required during installation)

1. The image below shows the supports to be removed (The black arrows indicate manually added model supports for the 1.5x larger version, the small version does not have them if supports need to be changed, ungroup the model) and brims (those in the red circles if brims need to be changed, ungroup the model)

2. Recommended tools are scissors or flush cutters peeling by hand is also possible but not as neat Be careful when using tools

The GIF below shows the assembly diagram:

First, install the wheels (note the direction, with the step facing outwards, see image below) onto the bracket, then attach the fuselage Be careful to apply even force when installing the left and right cannons, and do not break the buckles

Second generation Swift Fighter V2:https://makerworld.com.cn/zh/models/1211511-ji-su-zhan-ji-v2-ke-dong-wu-xu-wu-jin-jian#profileId-1288008

Note: 1. Both PLA and PETG can be printed. It's best to understand the characteristics of these two materials before printing to avoid printing failures!! For example, PLA can become brittle if left for a long time or at low temperatures, while PETG has good toughness. Please choose the filament that suits you!!

        2. If it's for younger children, and the parts are small and easy to disassemble, it's better to glue them firmly with 502 or other adhesives to prevent them from being swallowed!!

        3. If there are no special requirements, please do not use your own advanced process settings for printing~ to avoid printing failures!!

If your printd part has local spaghetti, or the filament doesn't stick to the build plate, please recall if you touched that area (hands secrete sweat and oil, touching it has a very high chance of causing spaghetti)  or if the build plate is dirty. The solution is to search online for how to clean a 3D print plate!! If other problems occur, please describe it in the comments section and add pictures, so it's easier for us to solve it~  Otherwise, I can't imagine the situation = =!!