Removable and reusable spool (180mm, re-bundle filament to avoid spool occupation)
Print Profile(2)
Description
Detachable and reusable spool, 180mm diameter, printable with A1 mini, compatible with Bambu Lab official filament, fits most brands of 1kg master spools, barely fits JAYO 1.1kg master spools (verified to just fit, requires careful assembly) Compatible with AMS lite
Features
- Features a large opening to observe remaining filament, with the opening flush with the axle, allowing re-threading of the tie strap when the filament is not fully used to remove the remaining filament and replace it with new filament, preventing the spool from being occupied by remnants
- Filament can be clipped to the internal clip
- Available in two configurations, one compatible with official filament labels, the other with double-sided 3x3cm label slots for printing your own filament information
Installation method: Align and twist the upper and lower spool halves tightly until they visibly lock into place, then insert the small washer into the center of the axle (as shown in the figure)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)