Finger Splint (Fingerschiene)

This is a finger splint designed to protect the distal interphalangeal joint from bending.
It is used for tendon injuries or finger fractures.
It is designed for a finger diameter of 18 mm Measure your finger at the joint and scale accordingly.
For PLA printing, increase the bed temperature to 65°C for the first layer to improve adhesion, then reduce to 50°C.
After printing, immerse in boiling water for approximately 10-15 seconds and then adjust to fit your finger The PLA will be pliable but not too hot to handle.
Subsequently, round off the edges and corners as desired using scissors or a nail clipper