Search models, users, collections, and posts
Spider Farmer - Mounting Aid for GGS Controller
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
20
44
5
0
69
44
Released
Description
Content has been automatically translated.
Hello everyone,
Since I couldn't find a model for the current version of the Spider Farmer exhaust kit, I made a mounting aid for the new GGS controller myself.
This fits exactly into the rear mount of the controller and snaps easily into place.
For my own copy, I used PETG HF. The print time on the Bambu P1S was 15 minutes. Approximately 5.5g of filament.
No supports are needed. If any strings form on the overhangs, these can be removed with a sharp blade or a soldering iron.
The opening in the model fits exactly the following hooks:
https://makerworld.com/de/models/592906-grow-tent-pole-clip-16mm#profileId-514648
Have fun with it and good luck with printing and installation :-D
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)