SteamDeck Support V01 w/ SD Card Slots

This is a snap-on support for the SteamDeck (Tested only on my LCD version) No screws required! 
The support features a unique design that incorporates 6 slots for microSD cards. The Cards have a Locking tab to keep them in place. I am using this for some months without any issue, but any comments to make it better are welcome. You're also free to Remix it ! 
While folder, It fits inside the original SteamDeck carrying case without needing to be removed.
The print can be done in multi-color (AMS) or single color.
Prints in under 2 hours at 0.2mm layer height with minimal organic supports.
Printed in PLA on the Bambulab A1. 

Note 01: To fix the MicroSD holder on the back, use super glue. Make sure it's aligned with the cavities underneath so the tabs can be pushed down to unlock.

Note 02: This model didn’t fit tightly on the OLED in a single test I did, which is odd since Steam says both versions are identical so it SHOULD fit perfectly. Feel free to test it yourself. The support has a recessed area for 3M double-sided tape in case it doesn’t stay in place. Which might happen depending on your filament or print tolerance.