Search models, users, collections, and posts
Nendoroid Display Stand
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
80
192
7
2
120
72
Released
Description
Content has been automatically translated.
V2 optimized version released: no supports needed, smaller base footprint, and strengthened structure at weak points.V2 model link
Pin display stand, insert the pin from the back of the badge into the slot to secure it, very stable when displayed. (The card slot has been reinforced, it is no longer easy to break when removing supports)
- Suitable for pins with a diameter of 75mm or less
- Display angle is approximately 15 degrees
- Very material-efficient, each stand uses about 3g of filament
Boost Me (for free)
If you like the model, please boost me, thank you very much!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)