Search models, users, collections, and posts
Raspberry Pi Camera Mount ender3 Pro
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
59 min
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
0
2
0
0
9
3
Released
Description
Summary
This is a Remix of https://www.thingiverse.com/thing:4350729
I made this remix to fit an Ender 3 pro, original design was for a regular Ender3. I extended the clip of the mounting area and also made room for the Y motor belt to run without interruption. I also used the same idea at the original by including supports on the modified section that should remove easily once printed.
Pictures are from an early test print.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Resolution:
.02
Infill:
20
Filament: AMZ3D PLA OrangeThis remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)