Flower Blossoms Bookmark Set - Color Customize

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

This bookmark set is a unique one that I carefully crafted so you may paint the flowers to the color that you want. It is set in a frame to mimic a wrought iron arch. The print profile has 2 independent bookmarks that will stand on their own. I took into account of all the different manufacturers' colors and their wide range of filament's TDs(transmission distance). I have given enough layers for  you to paint the flowers with the color of your choosing independent of low or high TDs. To paint your flower, choose your color in place of the Hot Pink. The white swap at the end are for the variation in tones for your flower and give it depth. The main one uses Hot Pink(pictured below), while the others from left to right are white, blue-purple dual silk, orange-pink dual silk, and yellow. If you want a solid color flower, just choose your flower color also for the white (I advise this only for silk PLA multi colors only) as it give variations on their own merit. For the tree bark, you can use brown, orange or black. Share your colors and prints.

Flower Blossoms Bookmarks

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Brown Transmission Distance: 2 (Orange or Black is acceptable)
    PLA BambuLab Basic Hot Pink  Transmission Distance: 3.9  (Choose Your Flower Color)
    PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer (1.2mm) swap to Brown (Orange or Black is acceptable)
    At layer (1.36mm) swap to Black
    At layer (1.52mm) swap to Hot Pink (Choose Your Flower Color)
    At layer (2mm) swap to Jade White for the rest.
 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections