Headphone Hook Stand Desk Clamp SUPER STRONG

Why This Exists

Most printed headphone hooks snap, slip, or sag. I redesigned the genre from scratch—no fragile arms, no cosmetic gimmicks. Just unapologetic strength, bold geometry, and the polish you expect.

Key Features

• Two Hooks, One Clamp – park your primary headset up top and stash loose cables on the lower arm.
• Engineered for Strength – 6 perimeter walls + 15 % adaptive cubic infill
• Chamfered Everywhere, Filleted Where It Counts – crisp styling where you see it; generous radii in every high‑stress corner to diffuse load and prevent layer tear‑out.
• Full‑Foot Contact Clamp Pad – a broad, flat pressure plate spreads force evenly across the underside of the desk, protecting both clamp and desktop.
• Ergonomic Thumb Wheel – smooth star grip makes tightening or releasing effortless.
• Universal-ish Fit – clamp is tall enough for 35 mm thick desktops (measure yours to be sure). If you need thicker, let me know.

Assembly & Hardware

1. Print the clamp body, thumb screw and screw head.
2. Insert thumb screw into the clamp body and screw clockwise
3. Optionally add a thin sticky pad or a strip of electrical tape to the clamp pad and upper jaw for glass‑smooth desks.

Usage Tips

• Tighten until the clamp pad is firmly seated—no need to over‑torque.
• For ultra‑slick laminates, use double‑sided tape on the pad for extra grip.
• The lower hook is perfect for secondary cans, random things, VR straps, or cable management.