Search models, users, collections, and posts
Running Bib Magnet Clip
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
2 h
5 plates
Open in Bambu Studio
Boost
53
140
8
3
154
73
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Round Magnet
x16
Description
This print is to hold your Running Bib to your t-shirt with a Magnetic Clip rather than a safety pin. I tested these by racing a 5K with no issues. Each clip set is made of two parts (one for inside and one for outside your shirt). Each side requires two magnets (16 magnets total for 4 clip sets). Magnets push into print, no glue required. NOTE! My magnets are 8x2mm but measure 8x1.75mm
Magnet Size: 8mm x 1.75mm
Magnet Qty: 4 per clip (2per side)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)