Search models, users, collections, and posts
UDA TAG for air tag
Print Profile(2)
0.2mm layer, 4 walls, 25% infill
Designer
1.3 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
44 min
2 plates
Open in Bambu Studio
Boost
29
37
4
0
38
25
Released
Description
The tougher the air tag case, the more expensive it tends to be. Since I have a 3d printer, I decided to create one. The logo is original, but you can change it to your own name, no problem. it is sandwiched between TPU, so I can't guarantee water resistance, but I think the water resistance is good. One point it is highly sealed and the sound is muffled. The detection feature will help when searching outdoors.
We recommend M 3x12 stainless steel bolts. Also, if possible, the screws should be tapped to increase their durability. If not, it can still be used, but its durability will be reduced.
The filament is made of Bamboo PLA Matte.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)