ray vise spool holder hand-held bracket (compatible with ray vise)

This egg tray is based on my previously released Vise 2.0, and therefore does not support Vise 1.0. Pairing with Vise 2.0 requires M6*8 socket head cap screws (during storage, reverse the screws and tighten them from inside the shell). No additional parts are needed when using with a RAY vise.

The file contains three shell versions:

                                                                                Heat-melt version: requires M6*6*8 knurled nuts (hardware) to be melted into the top using a soldering iron

                                                                                Non-heat-melt version: requires M6*6*8 knurled nuts (hardware) simply glued in place

                                                                               No knurled nut version: ready to use, but may loosen over time.

Update: 1. Due to adjustments to the vise knob, the bottom of the egg tray has also been redesigned to match. 2. A version with holes added to the egg tray lid allows screws to be left in the top during storage (though this compromises the aesthetic appeal of the tray).