Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
2
5
1
0
6
6
Released
Description
Loved the OP concept, but I needed more of a tear- off option. The bags kept pulling out of the dispenser. Printed vertically with no supports. Made a horizontal opening in the bottom to allow the width of the bag to feed through and closed the front to prevent the bags from popping out. I also made the magnet holes less deep to 2.5 mm to accommodate a thinner magnet. The OP print is amazing, well designed and sturdy. I just needed a bit more for my use case. Why reinvent the wheel?
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)