Search models, users, collections, and posts
Gorilla hot glue gun trigger
IP Report
Print Profile(1)
0.2mm nozzle, 0.1mm layer, 7 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
5
6
0
0
12
4
Released
Description
The original trigger on mine broke, so I made a new one to repair it.
Comes with an over-travel stop to prevent unnecessary stress.
Printed mine with a 0.2mm nozzle but should be fine with a 0.4mm nozzle too.
Use extra wall perimeters and top-bottom shell thickness to ensure strength.
Print out of heat resistant material.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)