Ikea Skadis Wire Spool Holder
Print Profile(1)
Bill of Materials
Description
Looking around at the other wire spool holders out there, I wasn't terribly satisfied. All seemed to use a bit more filament, had finicky printing (supports, post processing), or just wouldn't hold the number of spools I had.
So I made this one. It holds 6 spools, has feed-holes in the bottom front, and supports holding 6 spools up to 60mm in diameter.
Since this uses the Skadis T-Nut system, you will need the following hardware:
- 2xM2.5x10 Bolts
- 2xM2.5 Nuts
I've added these to the BOM below, so if you don't have any on hand you can purchase some from Bambu Labs
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)