Search models, users, collections, and posts
Card Saver 1/ Semi Rigid Box & Snug Lid (S, M & L)
IP Report
Print Profile(2)
"CARD SAVER I" 0.2mm layer, 3 walls, 20% infill
Designer
4.3 h
1 plate
No Words (BLANK) Assorted Sizes
Designer
19.2 h
3 plates
Open in Bambu Studio
Boost
33
99
15
5
226
161
Released
Description
Boost Me (for free)
Like the model? Give me a boost!
Simple box for storing Card Saver I (Semi rigid).
They fit snug inside with no room to slide sideways.
You can lay them down flat too if you want.
No supports needed. The lip of the box is pretty sturdy and fits on the box pretty snug, just dont lift it by the lid.
Added a blank box that you can customize to your needs.
Also added smaller sizes to the Blank profile. 40mm + 85mm + 135mm (Original)
Check out my new Sliding Lid Card Saver box (Scale it along the Y-Axis)
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (15)