lollypop toy
Print Profile(1)
Description
I made a funny lollypop toy. Printing and assembling processes are both quite simple.
It be appropriate for lollypop (diameter less than 3cm and stick's diameter less than 3-4mm)
hope you like it.
Installation is as shown in the picture.
Assembling the model requires a rubber band.
Installation according to the corresponding part number.
rubber band is being tightened as much as possible.
This model was printed using PLA. (fill in 10，using a lower layer high (0.2mm)，no support)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (26)