CatSnap - Photo Stand
Print Profile(1)
Description
Membership
Do you like this model? Want to monetize your prints? With this Commercial Membership you are authorized to sell my designs anywhere: fairs, retail outlets, social media, and marketplaces (Etsy/Shopify). There is also an option that allows the use of official photos and descriptions to create listings that convert.
😸 A cute kitty that shows off your memories
Built-in spiral clip holds photos, postcards or business cards—just slide your image in and let the cat display it with charm.
⚡ Blink-and-it’s-done print
- Only 10 g of PLA, about 20 minutes of print time
- 0.4 mm nozzle | 0.20 mm layers (0.12 mm for a finer finish)
- No supports required
- 15 % infill; solid where it matters
🧩 Extra stability
A tiny wedge is included: slip it into the slot under the base for rock-solid balance, even with wider landscape photos.
💡 Use ideas
- Desk or night-stand photo display
- Fun place-card holder for parties or weddings
- Eye-catching business-card stand at fairs
Take a look to other subjects:
 |  |
 |  |
 |  |
👉 Check out all my models here: My MakerWorld Profile
Boost Me (for free)
📢 If you like this project, leave a like and a boost to support me!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (120)