F1 DRS Key Hanger

Materials needed :  

- Rubber bands listed below  

- 2 Drywall Screws
- 2 Filament strands from 10mm to 20mm long - these serve as pivots 

Printing Instructions:
Easy 3MF File, AMS not required , Choose single or double hook, choose which endplates, and Second Element_Bars or just print it all on one plate!

Assembly instructions: 

Step 1: 

• Gather all Printed Pieces + screws + rubber bands 

Step 2: 

• Insert filament into endplate holes, this should be snug 
   

Step 3: 

• Gather main element and one endplate. Push the main element onto the endplate 

Step 4: 

• Gather second element and bars and place them together as shown below

Step 5: 

• Gather steps 3 and 4 and place them on the endplate. Make sure the slide the filament into the second element

Step 6: 

• Gather rubber bands and place them in around the two small holds, one band will hang  ( On bar and on endplate ) 

Step 7: 

• Grab the other endplate and line it up with the main element and second element, placing on the rubber band. 

Step 8: 

• Grab your hook of choice ( single or double ). And place in in between the endplates attaching the bars to it as well 

Step 9: 

• Grab screws and put them in the holes. The holes, center to center, measure about 129mm apart. Screw in with a screw driver and DRS active.

Step 10: 

• Place keys on the hook and I hope you enjoy!