Nespresso cups holder - Accessory kitchen/coffee

Small Cup Holder

Design of a cup holder suitable for small cups of approximately 55 mm in diameter, generally used for short coffees like Nespresso.

Printing:

To save time, you can print the piece at 0.20 mm or even 0.24 mm.
The patterns are simple, the curves are not complex: a thicker layer will have little impact on the final result.
Personally, I printed it at 0.20 mm.

Installation:

Allow for 3 standard screws to ensure a good hold of the cup holder.

It is also possible to install it vertically to hang the cups according to your preference or available space.

Feel free to provide feedback in the comments, share your photos, leave a like and a boost if you enjoyed it. 
Happy printing everyone!
Epsilon