Rainbow Stanley Cup Straw Topper

Requires only 1 AMS but also works with 2. 

Three versions available: 3 colour, 4 colour and 6 colour. These can all be edited in the slicer and makes it easy to adjust for the different LGBTQIA+ flags. There is also a rainbow only version without clouds.

The clouds are printed separately and glued on.

For 3-4 colours:

These are easy, just print the labelled plates and assemble the clouds (or not).

For 6 colours with 1 AMS:

Right this one took a while to actually figure out because I really wanted 6 but I only had 1 AMS. You will need to print 2 plates - each using 3 colours each. These are labelled in the 6 colour version as P1 and P2 (with or without clouds). The coloured pieces are printed FLAT on the bed and then clicked into place with the little attached connector. I find the tolerances a perfect fit with my filament but you can add a drop of glue for security if yours are loose.

Assemble the small rainbow pieces first (with connector) then glue the two halves together. I have not figured out a better way to do 6 colours on this design with 1 AMS but if there are suggestions do let me know.

For 6 colours with 2 AMS:

There's a separate labelled plate for users with 2 AMS - just print this one.

Other settings:

I have ironing switched on in profiles because I prefer the look of them but feel free to turn it off if you want a quicker print.

Thanks for taking a look, any questions just message me or leave a comment. 

Boost me for more designs! For this topper, boosts will go towards a local LGBTQIA+ charity near my town.

Commercial license available on my Patreon in my profile if you’d like to sell these.