G1 Docobot: Buttons

UPDATE: 12/26/2025: I've altered the head to help strengthen it and added holes in the feet to allow for 4x2mm magnets as per feedback that I've received.

 

Today we have the fourth Docobot in the Produce Wars series, Buttons!


This is the first bot in the series that doesn't have a weapon. The print time is fairly quick. About two hours for everything but the head. I've added two heads to the profile, a three colour head (pictured) and an alternate two colour head. The three colour takes 1h45mwhile the two colour only take 45m.

If you find the joints are too loose, try printing the ‘bones’ with fuzzy skin turned on.


ASSEMBLY GUIDE

Assembly is very basic and completed in seconds.
 

The neck will be the short, tan ‘bone’. Take it and connect the head to the torso.
 

Now take a shoulder, the right arm and right hand and connect the hand to the arm, the arm to the shoulder and then the shoulder to the torso. Repeat the steps with the left arm.
 

Now connect the feet to the torso using the leg bones, and you're done assembly.

TRANSFORMATION GUIDE

Transformation is very easy with Buttons. First, you will need to flip the head back and into the chest cavity, making sure that you can't see the eyes.
 

Next, fold the legs back and rotate the thighs as seen in the picture below.
 

Now fold the hands inside the arms, making sure that the palm of the hand is facing out as seen below.
 

From there you fold the arms in and then the feet as well, and you're done.