Search models, users, collections, and posts
Precision Minimalist Scraper
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
2 plates
Open in Bambu Studio
Boost
12
19
3
1
41
27
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Bambu Filaments
Select all
Description
- Optimized blade angle for effective scraping without damage
- Comfortable rounded handle, around 15 cm long
- Safety cap included
- Easy 1 hour print using ~28g filament, no supports needed
- Uses Bambu Lab’s supplied blade and screws
Two variants included: one with a hanging hole, one without
Materials Needed
- ~28g PLA (or any other filament you like)
- 1x Bambu scraper blade (included with printer)
- 2x BT2.6-8 self tapping screws (also included with printer in the “For Scraper” bag)
2 mm Allen key
Assembly
- Insert both screws into the angle piece
- Screw the angle piece onto the handle — but leave a gap
- Slide the blade into the gap and push it against the screws
- Further tighten the screws while keeping the blade pushed back
(Tip: Put on the cap during assembly for safety)
Boost Me (for free)
boost pls? 🥺👉👈
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)