Search models, users, collections, and posts
Cabinet Straw Holder
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Hex pattern on bottom
2.5 h
1 plate
Open in Bambu Studio
Boost
437
1799
123
24
1.6 k
1.3 k
Released
Description
**This model was redesigned from scratch, but was based on Edwin Velez's design, here: https://makerworld.com/en/models/986859-straw-holder-cabinet-door?from=search#profileId-961715
This is a simple straw holder that can be placed in a cabinet door with command strips. It has 4 sections to help prevent straws from sliding down. There are separate base and support parts to save on print time and material, and to allow for different straw height support. It's depth is about 1", which should be narrow enough for most cabinets to close properly. Hexagon walls help to save on print material.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (123)