Rubbermaid Brilliance Cantilevered lid holder - V2

V2 Update - While the original models worked well, the large lid holders pulled off the wall after a few weeks. Due to that I added some M4 screw holes.  I also created various lengths as single pieces without the need to join individual pieces.  The small 2x sizes did not have a lot of holding power. 

I really liked Alice's remix for lid holders.  While Alice's design was meant to sit flat on the ground and have the lids stored vertically, such as in a drawer, I liked the idea of having the lids stored horizontally inside a cabinet.  For a while I used Alice's model and used it upside down to hold lids in the back of the cabinet, but what was really needed was a slight redesign so that he lids could be cantilevered into a locked position from the front.  I ended up with a complete redesign, but it all started with Alice's.

I have two versions.  One is for the smaller lids, and the second for larger lids.  The lids had a slightly different geometry that required something different for each.  

Please use 3M VHB tape or screws  to secure.