Adjustable laptop, iPad, e-reader, and phone stand modification for the AMS lite bracket

The AMS lite's ultimate destination is still to be modified with a lower bracket and placed into a large airtight enclosure.

It's a shame to discard the original unused bracket.

After three days and nights of research, a low-cost modification into an adjustable-angle stand has been created, usable for laptops, tablets, and phones, ensuring continued use at the desk.

All parts are 3D-printed, requiring no hardware.

Installation instructions:

1. Install the tablet first. Four holes are provided at the bottom, install the bottom hooks as needed; use the center hole for phones, and it's best to use the outer holes for pads or laptops. Simply tighten with a nut on the back. You can also install four hooks.

2. Install the bottom swivel. There are two shafts; use the shorter shaft at the bottom. Here's a tip: because printing the large tablet's holes will result in overhang at the top, simply use the shaft with its printed side facing the overhang, making installation effortless.

3. First install the two support brackets above the AMS lite, pass the two guides through, then install the top fixing shaft, again using the longer shaft and nuts to secure the two guides. With the bottom of the shaft facing the overhang of the large tablet's holes, installation is easier.

4. Install the adjusting shaft, tighten the two support brackets, and screw in the adjusting shaft from the right. Finally, approximately 4mm should be exposed at each end.

5. Finally, the adjustment: The adjusting shaft has a flat side. Align the flat side with the guide to allow the guide to slide up and down; facing the flat side away from the guide fixes the angle.

All done, time to relax with a good book or binge-watch a show.